Midland BTR1 ADVANCED - Page 3

MIDLAND INTERCOM PAIRING
Status: Settings (steady red led)
3” 3”
Press for 3 seconds
(You can use any key)
Press for 3 seconds
(You can use any key)
Flashes Flashes
Confirmation (1 sec.) Confirmation (1 sec.)
Exit Settings mode (Press the Control button twice)
PAIRINGS
PHONE/GPS/TFT PAIRING
Status: Settings (steady red led)
3”
Press VOL+ for 3 seconds
Beep
Flashes
Select BTR1 Adv. in your
phone, GPS or TFT
Beep
Confirmation (1 sec.)
Note: to pair a second device in mono audio, repeat the same procedure but
press VOL-.
OTHER BRAND INTERCOM PAIRING
UNIVERSAL INTERCOM
Status: Settings (steady red led)
3”
Press for 3 seconds
(You can use any key)
Follow the phone pairing
procedure
(see instructions of this device)
Flashes
Confirmation (1 sec.)
OBI INTERCOM PAIRING
Status: Settings (steady red led)
OBI intercom
(Cardo...)
3”
Press for 3 seconds
(You can use any key)
Follow the pairing procedure with
the intercom device
(see instructions of this device)
Flashes
Confirmation (1 sec.)
Attention: a new pairing on the same button overwrites the previous one