CT310 Instruction Manual | 3
Main features
• VHF/UHF dual band and channel displayed
• Operating modes: UHF/VHF, UHF/UHF, VHF/VHF
• Output power 5W UHF/VHF
• 200 memory channels
• 51 CTCSS tones and 1024 DCS codes
• 1750/1450/1000/2100Hz repeater tones
• SOS Emergency function
• FM radio receiver (76-107.95MHz)
• VOX, Scan, frequency band scan
• Mode selection: channel/frequency/name
• Talk Around feature (TX = RX)
• Frequency step: 2.5/5/6.25/10/12.5/20/25/30/50KHz
• Adjustable frequency oset: 0 – 69.9975MHz
• Dual transmission (PTT and SUB PTT keys)
• Stop Watch
• Automatic power o 30min/3 hrs
• Li-Ion battery pack 7.4V 1200mAh
• 2pin Kenwood accessory jack
Programming software
Thanks to the Midland Programming software PRG-G10, it is possible to
increase the performance of your radio or to reduce its functionality by
enabling or disabling some features.
For further information, please consult the Programming software manual.
When programming the transceiver, read the factory initial data first, then
rewrite the frequency and signaling etc., otherwise errors may occur because
of dierent frequency band etc.
To Next Page
Loading...
