Midland G7XT User Manual

5
Picture 1
Picture 2
Do not overcharge baeries! When these are fully charged, the charging process may
not stop automacally. Do not forget to detach the wall adaptor from the radio as
soon as the baeries are charged.
Do not try to charge alkaline baeries or non-rechargeable baeries. Make sure
that when you charge the radio, only rechargeable NiMH baeries are ed in the
baery compartment! It is dangerous to aempt to recharge other types of baeries
(for example alkaline or manganese baeries). Baeries which are not suitable to be
recharged may leak, explode or even burn and cause damage!
Using a dierent baery charger other than the one specied can cause damage to
your device.
Do not throw baeries into re or place them near heat as this may cause injuries.
Dispose of baeries according to local regulaons. Do not mix old and new baeries
or baeries of dierent types.
4.2 Installing and removing the belt clip
The belt clip easily aaches the transceiver to your belt. This clip must be removed to
replace the baeries. To remove the belt clip follow the illustraon below. To re-ax
the clip, slot into the guides at the back of the transceiver unl it locks into place.
4.3 Removing/Installing the baeries
4.3a Removal
1. Remove the belt clip as depicted in
Picture 1.
2. Open the baery compartment as
shown in Picture 2.
3. Remove the baeries.
4.3b Installaon
1. Install the new baeries into compartment.
2. Re-ax the baery cover and belt clip.
5. BASIC OPERATION
5.1 Turning on/o
To turn on the transceiver, turn the Volume [11] knob clockwise unl you hear it click.
The LCD display will light up and do an Auto-Test. Subsequently you will hear 3 beeps
of dierent tones. To turn o the transceiver, turn the knob counter-clockwise unl you
hear another click. The LCD display will turn o and subsequently you will hear 3 beeps
of dierent tones.

Midland G7XT Specifications

General

Brand	Midland
Model	G7XT
Category	Radio
Language	English