12
Reset Function
When the radio is off, press PTT+PRI+POWER at the same time.
During resetting, the software version number (current version number is 4A) will be
displayed. After reset, the radio will be in the default setting.
Default Setting Table.
Call Tone
Press Call button and the radio will send a call alarm signal. The caller can hear the tone to
confirm the display. There is a TX icon displayed.
Note: When you send out an alarm signal, the signal will only last for three seconds in a
minute.
After one minute the alarm will continue.
Call Tone Setting
1. Briefly press the menu key to enter the menu.
2. Press ▲ or ▼ key to select and stop when the LCD display “CA”. Press the key to
confirm and enter calltone setting.
3. Press ▲ or ▼ key to choose the desired setting, and briefly press the key to
confirm. There are 5 kinds of sounds from 01 to 05.
SQL 5
Roger Beep OFF
CTCSS/CDCSS OFF
Volume 6
Beep ON
Backlight 07
Call Tone 1
To Next Page
Loading...
