Need help?Do you have a question about the Midmark UltraClave M9 and is the answer not in the manual?
Primary concern for safe operation and maintenance of equipment.
Definitions of DANGER, WARNING, CAUTION, EQUIPMENT ALERT, and NOTE symbols.
Details overall dimensions, chamber size, tray sizes, and unit weight.
Specifies voltage, frequency, circuit needs, and power consumption.
Covers door stop, closed switch, and water low indicator functions.
Describes overheat protection, pressure relief, and fault detection circuits.
Specifies placement, clearances, and surface requirements for optimal operation.
Outlines steps for safely moving the sterilizer.
Overview of sterilizer purpose and items it can process.
Describes automatic cycle initiation, filling, sterilization, and drying phases.
Details function of Temperature/Time, Pressure, Filling, Sterilizing, Drying, and Complete indicators.
Explains buttons for START, STOP, ON/STANDBY, and cycle program selections.
Describes Water Low, Door Ajar, and Error indicators.
Details the Unwrapped, Pouches, Liquids, and Packs program cycles.
Explains Start, Stop, and On/Standby padswitch functions.
Steps for initial setup, including power connection and serial number check.
Guides on cleaning, washing, rinsing, and drying instruments.
Instructions for arranging instruments and pouches in trays.
Procedures for using process indicator strips and biological spore tests.
Outlines the four basic steps to start a sterilization cycle.
Explains the automatic shutdown sequence and power failure handling.
Table detailing program cycles, temperatures, pressures, times, and items to sterilize.
Step-by-step guide for initiating and running a sterilization cycle.
Instructions for cleaning external surfaces and door gasket.
Procedures for cleaning the sterilizer chamber and trays.
Steps for flushing the system with a special cleaner.
Monthly procedure to test the pressure relief valve functionality.
Instructions for cleaning or replacing the chamber filter.
Procedure for cleaning the door and dam gaskets.
Recommendation for yearly replacement of the HEPA filter by service personnel.
Steps for installing the optional printer unit.
Details on connecting printer harness and placing the printer unit.
Explains how to use the paper feed switch for the printer.
Step-by-step guide to load the paper roll into the printer.
Instructions for replacing the printer's ink ribbon cartridge.
Procedure for safely removing the paper roll from the printer.
Information on what data the printer outputs for each cycle.
Explanation of data recorded during heat up and sterilization phases.
Lists common problems like water low, door ajar, error lights, and steam leaks.
Details specific error codes and their possible causes and remedies.
Outlines what the warranty covers and what it excludes.
Specifies the exclusive remedy and authorization for repairs.
General| Brand | Midmark |
|---|---|
| Model | UltraClave M9 |
| Category | Laboratory Equipment |
| Language | English |
To Next Page