EasyManua.ls Logo

Midtronics xMB-9640

Midtronics xMB-9640
26 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Hazardous voltage.
Do not remove protective covers.
Failure to follow this instruction may result
in electric shock, personal injury, or death.
Circuit boards, test points, and output voltages also
may be oating above or below chassis ground.
This xMB-9640 is designed for
indoor use only.
Do not operate the xMB-9640
outdoors.
Operation of the xMB-9640 in
an outdoor environment can
result in equipment damage.
Risk of explosion.
This device contains internal arcing and sparking parts which should not be
exposed to ammable vapors. This device should be located at least 18 inches
(457mm) above grade. Failure to follow this instruction may result in personal
injury or death.
Risk of explosive gases.
Batteries may generate explosive gases. To reduce risk, follow these
safety instructions and those published by the battery manufacturer
and OEM. Failure to follow these instructions may result in personal
injury or death.
Charging a non-rechargeable battery may
cause the battery to burst.
Only charge batteries for which xMB-9640 has been
designed and is intended for use. Failure to follow these
instructions may result in personal injury or death
The xMB-9640 has not been designed for exposure to rain or snow.
Operate the xMB-9640 only indoors in a clean environment. Failure
to follow these instructions may resulit in equipment damage.
Only qualied technicians may use this equipment.
The required qualications vary by region. Always
observe local laws and legislative directives.
Failure to follow this instruction may result in serious
personal injury or death.
Hazardous voltage.
An improper connection can result in electric shock
To avoid electrical shock or burn, never alter the xMB-9640’s original AC
cord and plug. Disconnect plug from outlet when xMB-9640 is idle. Failure
to follow these instructions may result in personal injury or death.
Risk of explosive gases.
Never smoke or allow a spark or
ame in the vicinity of a battery.
Batteries can produce a highly explosive
mix of gases, even when the battery
is not in operation. Always work in a
well-ventilated area. Failure to follow
these instructions may result in personal
injury or death.
Wash hands after handling.
REQUIRED BY CALIFORNIA PROP. 65: Battery
posts, terminals, and related accessories may
contain lead and lead compounds, chemicals
known to the state of California to cause cancer
and birth defects or other reproductive harm.
Hazardous voltage.
An improper connection can result in
electric shock
To avoid electrical shock or burn, never alter the xMB-
9640’s original AC cord and plug. Disconnect plug
from outlet when the xMB is idle.

Related product manuals