Filling the salt reservoir
28
Setting the water hardness level
The water softener can be set between 0 - 12.6mmol/l (0 - 70°dH).
Select the Further settings menu.
Select Water hardness and confirm your choice with the OKbutton.
The factory setting for the water softener is set to a water hardness of
3.4 mmol/l (19 °dH).
When adjusting the setting, please consult the following table.
With varying water hardness, always set the highest level. Where the
water hardness fluctuates, e.g. between 1.4 - 3.1 mmol/l (8 - 17 °dH),
always programme the dishwasher to the higher value, 3.1 mmol/l (17
°dH) in this example.
Use the and arrow buttons to set the water hardness required
and confirm your entry with the OK button.
To Next Page
Loading...
Need help?
General
