Warning and Safety instructions
11
Correct application
Emitted steam, the iron soleplate together with the areas
surrounding it on the iron, and the steamer jets are very hot.
Danger of burning!
Avoid direct contact.
The steam ironing system is intended for domestic use only and is
not designed for commercial purposes.
Do not use a pressure washer or hose pipe to clean the steam
ironing system.
Clean the steam ironing system only after it has cooled down.
Danger of injury by crushing! Do not reach between moving parts
when assembling, dismantling or adjusting the height of the steam
ironing system.
The steam ironing system must only be set up on a level surface
which has the appropriate load-bearing capacity. The steam ironing
system must only be used in a horizontal position.
The steam ironing system must be assembled when ironing.
However, the steamer can be used when the ironing board is in the
upright position.
Ensure that the power cable does not present a trip hazard when
unwound.
Use caution when the appliance is heated. There is an acute risk
of burning if you come in contact with the soleplate of the iron or the
steamer jets. The warning symbol “Hot surface”() on the iron
indicates that it is hot.
Do not use solely demineralised water (e.g. distilled, battery
water) to fill the water container. This could cause the steam ironing
system to malfunction.
To Next Page
Loading...
