Dismantling
44
Set the ironing board to its
lowest working height
To dismantle the steam ironing
system, the ironing board must first be
set to its lowest working height. Make
sure you do not trap the power cable
in the system. Ensure the residual
water drawer is completely emptied,
pushed in and locked in place.
Turn one of the rotary dials on the
side of the tower handle as far as it
will go in the direction.
Hold the rotary dial in the position.
The height of the ironing board can now
be adjusted.
Keep holding the rotary dial in the
position and, simultaneously, use the
handle on the tower to push the
ironing board down as far as
possible.
Never push on the ironing board to
push it down.
Use only the handle on the tower to
push the ironing board down.
Release the rotary dial.
The rotary dial will spring back into the
centre position.
The ironing board is now at its lowest
working height and can be folded away.
After withdrawing the plug, drops of
water may escape from the steam hose.
To Next Page
Loading...
