Switching on
29
Filling the water container
If the water container is empty or not
installed in the tower, the message
Fill water cont. will appear in the
display.
Removing the water container
Hold the water container by its
handle.
Pull the handle downwards.
The water container is released from the
retainer.
Pull the water container upwards and
out.
When removing the water container,
you may notice some water dripping
while the water container valves are
closing.
Tip: The dripping can be prevented by
removing the water container slowly.
Filling the water container
Open the screw cap at the rear of the
water container by turning the cap
anti-clockwise.
Remove the screw cap.
Use fresh tap water to fill the
container (water temperature approx.
15-35°C).
Tip: By placing the water container in
the horizontal position, the water
container can also be filled under very
low taps.
Replace the screw cap on the water
container.
Close the screw cap by turning it
clockwise as far as it will go.
Put the water container back into the
tower.
The water container can be removed
and refilled at any time (even during
the ironing process). The amount of
water required will depend on how
much steam is required.
To Next Page
Loading...
