Problem solving guide
69
Issue Cause and remedy
The temperature of the
iron is always high.
There is a fault.
Contact your Miele dealer.
The ironing board cover
is damp.
There is a fault.
Remove the ironing board cover and allow it to
dry.
Put the dry ironing board cover back on (see
„Cleaning or replacing the ironing board cover“).
If the ironing board gets damp again, contact your
Miele dealer.
Water is leaking from
the steam ironing
system at the height of
the water container
when it is being
transported.
The frequent removal and replacement of the water
container may cause water droplets to collect in the
area under the water container.
Use a cloth to dry the area underneath the water
container.
The fan on the ironing
board is not running.
Steam was not used.
The fan only runs when the steam function on the
iron is activated.
The appliance is not yet ready to produce steam.
Wait until the message Ready for use is
displayed to indicate that steam is ready.
The water container is empty or not inserted.
Fill the water container with fresh tap water and
insert it into the appliance.
The steamer is connected.
The fan only runs when the iron is connected.
Connect the iron.
There is a fault.
Contact your Miele dealer.
To Next Page
