EasyManuals Logo

Miele CS 1011 G User Manual

Miele CS 1011 G
52 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #26 background imageLoading...
Page #26 background image
,
Repairs to the gas and electrical
components of this appliance must
only be carried out by a suitably
qualified and competent person to
ensure safety. Repairs and other
work by unqualified persons could
be dangerous. The manufacturer
cannot be held liable for
unauthorised work.
Please note that a call-out charge
will be applied to unnecessary ser
-
vice visits where the problem could
have been rectified as described in
these operating instructions.
What to do if ...
... the burner does not ignite when
the cooktop is being used for the
first time or after a long period of not
being used.
There could be air in the gas pipe. You
may need to make several attempts
before the burner ignites successfully.
... the in-operation indicator and/or
residual heat indicator is flashing.
There has been a power cut.
An attempt to ignite the burner again
was not successful.
The gas supply has been
interrupted.
Turn all the controls clockwise to
position "ß". You can then operate the
appliance as normal.
If the problem persists, disconnect the
appliance from the electricity supply for
a few seconds.
... there has been a power cut.
Turn all the controls clockwise to
position "ß". You can then operate the
appliance as normal.
If the problem persists, disconnect the
appliance from the electricity supply for
a few seconds.
... the burner does not ignite after
several attempts.
Disconnect the appliance from the
electricity supply for a few seconds. If
the problem persists, check whether
the burner is correctly assembled.
the gas supply tap is turned on.
the burner is dry and clean.
the flame slits are dry and
unblocked.
... the gas flame goes out after being
lit.
During the ignition process, the flames
need to touch the ignition safety device
so that it heats up.
If the flames do not touch the ignition
safety device, check if
the burner components are correctly
in position.
there is soiling on the ignition safety
device. If there is, remove it carefully
(see "Cleaning and care").
Problem solving guide
26

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Miele CS 1011 G and is the answer not in the manual?

Miele CS 1011 G Specifications

General IconGeneral
BrandMiele
ModelCS 1011 G
CategoryCooktop
LanguageEnglish

Related product manuals