Miele CS 1011 G - To change the jet for the inner burner

To change the jet for the inner burner
d Jet disc (main jet for the inner
burner)
e Air intake sleeve
f Vent
^
Remove screw c from fitting b with
an SW 8 spanner while
counterholding it with an SW 12
spanner.
^
Remove screw fitting b from part a
with an SW 12 spanner while
counterholding it with an SW 12
spanner.
^
Remove the jet disc d from part a
and replace it with the correctly
numbered jet disc (see jet table).
^
Set the two vents f to a distance of
2 mm by sliding the air intake sleeve
e.
^ Screw all parts back on in reverse
order and check for leak tightness.
Conversion to another type of gas
46