Before using for the first time
25
Activating the cooker hood
The hob and cooker hood must be
switched off.
Press the run-on control for
approx. 10 seconds until 1 lights up.
Then press in turn:
– the control,
– then the control,
– then the lighting control.
The cooker hood is now in signing on/
off mode.
If a wireless connection has not yet
been established, 2 and 3 will flash at
the same time.
If a wireless connection has already
been established, 2 and 3 will light up
constantly (Con@ctivity 2.0 is already
activated or a remote control is signed
on).
To activate Con@ctivity 2.0 press the
control.
2 will light up constantly, 3 will flash on
and off.
After a few seconds 2 and 3 will light up
constantly, B will flash on and off.
The search for a wireless connection
will start.
Activating the hob
While the cooker hood is searching
for a signal, start activating the hob.
For further details, see the hob
operating instructions.
When the hob registers that a link has
been established, exit activation on
the hob.
To Next Page
Loading...
