,
Before installation, it is important
to read the information given on the
following pages as well as the
"Appliance dimensions" and the
"Warning and Safety instructions" at
the beginning of this booklet.
This is particularly crucial when
using the rangehood at the same
time as a heating appliance that
relies on oxygen from the same
room to avoid the danger of toxic
fumes building up.
Installation instructions
See enclosed Installation sheet for
instructions on how to install this
appliance.
Assembly parts
4 screws8x60mmwith
4 washers and
4 plugs S 10 to secure the cover plate
to the ceiling
,
The screws and plugs are for use
in concrete ceilings only.
For other types of construction,
alternative suitable fixings will be
required.
Make sure the ceiling is strong
enough to bear the weight of the
rangehood.
2 screws M4x8mm
for securing the tower.
4 spacers to use in the event of an
uneven ceiling.
1 floating bracket to give a choice of
position for the exhaust cut-out in the
ceiling.
1 hose clip for securing the exhaust
ducting to the exhaust stub.
Special installation instructions
for recirculation mode
In order to use the rangehood in
recirculation mode, it has to be fitted
with a special conversion kit which is
available from Miele (see "Technical
data"). It is supplied with its own fitting
instructions.
After the rangehood has been installed,
the charcoal filter has to be fitted, and
the operating hours counter has to be
set. See "Cleaning and Care" and "Filter
operating hours counter".
Installation
30
To Next Page
Loading...
