Miele DA6498WGG - Power Management; Safety Shut-Off

Operation (Manual mode)
30
 With the lighting switched on, press
and hold the lighting control. The
brightness will gradually dim until you
release the control.
 To increase the brightness, press and
hold the lighting control again until
the desired level has been reached
and then release it.
Power management
The ventilation hood is equipped with a
power management system. Power
management helps to save energy. It
ensures that the blower power level is
reduced automatically and that the
lighting is switched off.
- If the booster level is selected, the
blower automatically switches to
level 3 after 5 minutes.
- If the blower is set to level 3, 2, or 1,
it switches back one blower setting
after 2 hours and then in 30-minute
intervals until the blower eventually
switches off.
- The overhead lighting will switch off
automatically after 12hours.
You can deactivate power
management.
Keep in mind that this may increase
energy consumption.
Activating/deactivating power
management
 Switch off the blower and the lighting.
 Touch the delayed shutdown
control for approx. 10seconds,
until 1 lights up in the power level
display.
 Then press in order:
- the lighting control,
- the 1 control, and then
- the lighting control.
When power management is turned on,
the 1 and B indicators will be
continuously lit.
When it is turned off, the 1 and B
indicators will flash.
 Touch the 1 control to deactivate
power management.
The 1 and B indicators will flash.
 Touch the B control to activate power
management.
The 1 and B indicators will be
continuously lit.
 Confirm the setting by pressing the
delayed shutdown control.
All the indicator lights will go out.
If you do not confirm the new setting
within 4minutes, the ventilation hood
will revert to the previous setting.
Safety shut-off
If power management has been
deactivated, the ventilation hood will
switch itself off automatically after
12hours if it has been left on (blower
and overhead lighting).
 To switch it back on, press the On/
Off control or the lighting control.