Overheating protection
The overheating protection device is
located on the right-hand side of the
appliance underneath the On/Off
button. This switches the heating off
automatically if the temperature in the
steam generator gets too high. F27 will
appear in the programme/temperature
display and the cooling down phase
will begin.
The cooling down phase will be
completed in approx. 1 minute and
several beeps will sound. F27 will flash
in the programme/temperature display
for a short while and then three
horizontal bars ---will appear. After a
while F20 will appear in the display.
Proceed as follows:
^ Switch the appliance off and open
the door.
^ Allow the appliance to cool down for
approx. 30 minutes.
F20 will disappear from the display
during this time.
^
Remove the overheating protection
device cover cap (see arrow). Use a
screwdriver or similar to press the
button underneath in again.
^
Replace the cover cap.
The steam oven can now be used
again in the normal way.
If the overheating protection device
trips again, contact the Service
department.
Safety features
38
To Next Page
Loading...
