Technical Information
183
G 1xxx/G 2xxx
Function
Programming Display
Program running time
reduction
(ID nos. -984 and later)
Press the options button
22x. The “Tab” LED
flashes 2x slowly and 2x
quickly intermittently.
Press the Program button
as appropriate to make the
desired setting.
The display shows p and a digit
alternately. Setting options: p0 =
Standard setting; p1 = Program
running time reduction.
Temperatures are decreased and/or
hold times removed, so the program
running time is shortened.
Water quantity
normal/increased
(ID nos. -876 and later)
Press the options button
23x. The “Tab” LED
flashes 2x slowly and 3x
rapidly intermittently.
Press the Program button
as appropriate to make the
desired setting.
The display shows p and a digit
alternately: p0 = Normal water
quantity (standard setting); p1 =
Increased water quantity. If p1 is
selected, approx. 16.7 fl.oz.
(500mL) more water is taken in
during each water intake cycle.
Soak activation/
deactivation
Press the options button
24x. The “Tab” LED
flashes 2x slowly and 4x
quickly intermittently.
Press Program to change
the setting.
The display shows p and a digit
alternately. Options: p0 = Soak not
activated; p1 = Soak activated.
Pre-wash activation/
deactivation
Press the options button
25x. The “Tab” LED
flashes 2x slowly and 5x
quickly intermittently.
Press the Program button
as appropriate to make the
desired setting.
The display shows p and a digit
alternately. Setting options: p0 =
Pre-wash not activated; p1 =
Pre-wash activated.
Second interim rinse (ID
nos. -984 and later)
Press the options button
26x. The “Tab” LED
flashes 2x slowly and 6x
quickly intermittently.
Press the Program button
as appropriate to make the
desired setting.
The display shows p and a digit
alternately. Setting options: p0 =
Standard setting; p1 = With second
interim rinse.
Extended drying time
Press the options button
27x. The “Tab” LED
flashes 2x slowly and 7x
quickly intermittently.
Press the Program button
as appropriate to make the
desired setting.
The display shows p and a digit
alternately. Setting options: p0 =
Normal drying time; p1 = Extended
drying time (+10 mins).
Appliance height setting
2
Press the options button
36x. The “Tab” LED
flashes 3x slowly and 6x
quickly intermittently.
Press the Program button
as appropriate to make the
desired setting.
The display shows p and a digit
alternately. Setting options:
p0 = Normal machine height (G
1xxx); p1 = XXL model (G 2xxx).
Model setting
2
Press the options button
38x. The “Tab” LED
flashes 3x slowly and 8x
quickly intermittently.
Press the Program button
as appropriate to make the
desired setting.
The display shows p and a digit
alternately. Setting depends on
model and whether a circulation
pump with slide shutter (WAW) and
sensor softener (SEH) are installed.
p3 = G14xx, G24xx (w/out WAW,
w/SEH).
To Next Page
Loading...
Need help?
General
