Technical Information
204
G 1xxx/G 2xxx
Options:
Note:
Some of the following parameters can also be programmed via the Settings menu.
Function Programming Display
Reset
Select Reset. To restore
the standard settings,
select OK. To return to the
main menu, press Back.
The display reads Reset standard
settings?
Setting the language
Select Language.
Select a language and
confirm with OK.
The display lists the languages that
can be selected. A language must
be selected in order to return to the
main menu.
Setting the time of day
Select Time of day.
Select a submenu and
confirm with OK.
The submenus Format and Set
manually can be selected.
Format
Choose 24- or 12-hour
setup and confirm with
OK. Press C (clear) to go
back one level.
Display of both clock formats.
Set manually
Set the time (seconds,
then minutes) using the +,
- buttons and confirm with
OK. Press C (clear) to go
back one level.
Entry request is indicated.
Setting the detergent type
Select Detergent type.
Select a detergent type
and confirm with OK.
The display shows the selection of
available detergent types: Powder,
GEL, 2 in 1 and 3 in 1 for G 2830;
Powder, GEL and Tab for G 2832
and G 2872.
Dispensed rinse aid
quantity setting
Select Rinse aid. Select a
rinse aid quantity with the
+, - buttons and confirm
with OK.
The display shows the current rinse
aid dispensing quantities: The
dispensed quantity can be set from
0 to 0.2 fl.oz. (0 - 6 mL). Standard
setting: 0.1 fl.oz. (3mL).
Activating/deactivating
Drying Plus
Select Drying Plus.
Select a setting and
confirm with OK.
If the function is activated, the door
automatically moves to the drying
position at the end of the program;
see Section 080-2.7.
Setting the intervals for
the filter checks
Select Check filters.
Select a wash interval and
confirm with OK.
The display shows the intervals
available for selection. Range: 30 -
60 wash cycles.
Adjust Sensor wash
program
Select Adjust sensor
wash. Select a setting and
confirm with OK.
Setting options On, Off (standard
setting). (Yes and No for G 2872).
With this parameter, Sensor wash
can be adjusted for use against
stubborn stains (if overall soiling is
moderate). If this option is selected,
the main wash temperature is
raised to 131°F, resulting in an
extended running time.
To Next Page
Loading...
Need help?
General
