Programming the water sof-
tener
The programme touch pads are used
to programme the water softener. It is
possible to enter two separate values
for water hardness, using the touch
pad either singly (level 1) or in combina-
tion (level 2), (see settings chart).
For a level 1 value the indicator in the
touch pad lights up.
Example:
The indicator light
d comes on. The
water softener is set for a water hard-
ness of 130 mg/l (7°d German scale).
If the indicator in the 2 touch pad (Top
Solo) also lights up, the level 2 value
has been selected.
Example:
The indicator lights 2 and
d come on:
the water softener is set for a water
hardness of 310 - 400 mg/l (17 - 22 °d
German scale) (factory setting).
The k salt indicator light flashes to
show you are in programming mode.
To programme according to water
hardness level proceed as follows:
Open the door
Switch off the dishwasher
Press and hold in touch pads b and
d and at the same time switch on
the dishwasher. The "On" indicator
light comes on and the k and
c in-
dicator lights flash.
Warning: If some other indicator light
flashes switch off the dishwasher and
start again.
The following indicator lights can come
on in addition to the "On" indicator light:
b – The drying heat is switched off
(see section on "Additional
functions").
e – The buzzer is switched off (see
section on "Additional functions").
f – Special function for the Service
Engineer only.
Water softener
16
To Next Page
Loading...
