Add rinse aid only until it is visible on
the surface of the filter in the open-
ing.
Close the flap firmly.
The flap must audibly engage, other-
wise water could get into the rinse
aid storage container during the pro-
gramme.
Mop up any spilt rinse aid. This pre-
vents over-foaming occuring during
the next programme.
The flap should normally remain
closed. Only open it for adding more
rinse aid.
Wait until the indicator light H on the
control panel lights up before adding
more rinse aid.
Setting the dosage
The dosage adjuster (see arrow) in the
opening has settings from 1 to 6. It is
set to 3 at the factory, as the recom-
mended dose. The setting dispenses
approx. 3 ml rinse aid per programme.
If there are flecks on glasses after
drying use a higher setting.
If smearing appears on crockery use
a lower setting.
Adding rinse aid
22
To Next Page
Loading...
