Miele G 673 - Page 52

White residue on cutlery and
crockery
– No salt in the salt reservoir.
Fill the salt reservoir with dish-
washer salt for reactivation - see
section on "Water softener".
– Salt reservoir lid has not been
screwed on properly.
– Not enough rinse aid.
Use a higher dosage setting - see
"Adding rinse aid".
Water in the wash cabinet at the end
of a programme
– The drain hose is kinked.
– The drain pump may be blocked -
see “Cleaning and care”.
– Foreign bodies may be obstructing
the non-return valve - see “Cleaning
and care”.
The crockery is not sufficiently dry
– The drying heat function is switched
off.
Switch it back on again - see
"Additional functions".
The indicator light for the pro-
gramme selected flashes in the con-
trol panel when the door is opened
after the programme has finished
– The filter in the screw connection of
the valve on the water inlet hose is
blocked - see "Cleaning and care".
– Too little water flows into the wash
cabinet. This may be due to insuffi-
cient water pressure at the intake
(flow pressure at the water inlet).
– The drain hose is kinked.
– The drain pump may be blocked -
see "Cleaning and care".
All the indicator lights next to the
programme touch controls are flash-
ing after the door is opened at the
end of a programme
– There is a technical fault.
Please call the Miele Service Depart-
ment.
Problem solving guide
52