Miele G 7110 - Installation; Miele Waterproof system and water inlet connection

Installation
*INSTALLATION*
111
The Miele Waterproof system
Provided that your dishwasher has
been installed correctly, the Miele
Waterproof system will protect you from
water damage throughout its lifetime.
Water inlet
 Health risk due to wash water.
Water in the dishwasher is not
drinking water.
Do not drink any water from the
dishwasher.
 Health risk and risk of damage
due to contaminated incoming water.
The quality of the incoming water
must correspond to the drinking
water specification of the country in
which the dishwasher is being
operated.
Connect the dishwasher to a drinking
water supply.
The dishwasher may be connected to
cold or hot water (up to max. 60°C)
supplies.
If energy-saving water heating sources
such as solar energy circulation
systems are used, we recommend
connecting to the hot water supply. This
saves both time and electrical energy
costs. Hot water is used in all
programmes.
The SolarSaveprogramme (if available)
requires a hot water connection of
between a minimum of 45°C and a
maximum of 60°C (inlet temperature).
The higher the water intake
temperature, the better the cleaning and
drying results.
The water inlet hose is approx. 1.5m
long. A 1.5m long, flexible metal
extension hose (tested to
14,000kPa/140bar) is available as an
optional accessory from Miele specialist
dealers or the Miele Customer Service
Department.
A stopcock with a ¾"threaded union is
required for the connection. If a
stopcock is not available, only a
qualified installer may connect the
dishwasher to the drinking water
supply.
The water connection pressure must be
between 50 and 1000kPa. If the water
connection pressure is too high, a
pressure reducing valve must be fitted.