Miele G 7110 - AutoDos faults

Problem solving guide
98
Fault in the AutoDos (automatic dispensing)
Issue Cause and remedy
The following message
will appear on the
display:
Insert PowerDisk or
deactivate AutoDos with OK
The AutoDosfunction is active but no PowerDisk
has been inserted.
 Insert a PowerDisk (see “Detergent – Automatic
dispensing/AutoDos”).
 If you do not wish to use automatic dispensing,
deactivate the function using OK or the
AutoDosbutton.
The programme does
not start or a
programme that has
already started stops.
The following message
appears on the display:
AutoDos lid open
The AutoDos lid has not been closed properly.
 Close the AutoDos lid and lock it fully (see
“Detergent – Automatic dispensing/AutoDos”).
 If the lid cannot be fully closed, check whether the
PowerDisk holder is lying flat (see “Detergent –
Inserting a PowerDisk”).
 If the same fault message appears again, call the
Miele Customer Service Department.
The following message
will appear on the
display:
PowerDisk empty
Deactivate AutoDos with OK
The AutoDosfunction is active and the PowerDisk
is empty.
 Replace the PowerDisk (see “Detergent –
Automatic dispensing/AutoDos”).
If you do not wish to use automatic dispensing,
deactivate the function using OK or the
AutoDosbutton.
The message
PowerDisk empty
Deactivate AutoDos with OK
appears in the display
even though you have
inserted a new
PowerDisk.
The dishwasher was switched off when the
PowerDisk was replaced and it has therefore not
recognised the new PowerDisk.
 Switch the dishwasher on before replacing the
PowerDisk (see the “Detergent” chapter,
“Automatic dispensing/AutoDos”, “Inserting a
PowerDisk” section).