Cleaning and care
83
Cleaning the AutoDos
If the Clean AutoDos message is
displayed, check that the fill channel
is clean, and clean it if necessary,
e.g. powder residues. This helps
keep the AutoDos working properly.
In order to ensure that the AutoDos
works at its best, check it each time
you replace the PowerDisk and clean
it if needed.
1 PowerDisk holder
2 Fill channel for dispensing the
detergent from the PowerDisk into the
wash cabinet
Turn the AutoDos lid to and open
it.
Remove the PowerDisk if appropriate.
Pull the PowerDisk holder upwards
by the yellow tabs and remove it.
When doing so, do not pull on the
side tab.
Use the tab (see arrow) to release
the fill channel and pull it out .
To Next Page
Loading...
