Miele G 7110 - Water inlet and drainage faults

Problem solving guide
96
Water inlet fault
Issue Cause and remedy
One of the following
messages appears in
the display:
Open stopcock The stopcock is closed.
 Open the stopcock fully.
Water intake Before rectifying the problem:
 Switch the dishwasher off.
The water inlet is restricted.
 Open the stopcock fully and start the programme
again.
 Clean the filter in the water inlet (see “Cleaning
and care” – Cleaning the filter in the water inlet”).
 The water-connection pressure is lower than
50kPa.
Seek professional advice.
 The on-site connection for the water drainage may
be too low and you will need to vent the water
drainage (see “Installation – Water drainage”).
Fault F18 A technical fault has occurred.
 Switch the dishwasher off.
 Close the stopcock.
 Call the Miele Customer Service Department.