Miele G 7130 - Problem Solving Guide; Technical Problems

Problem solving guide
101
Many malfunctions and faults that can occur in daily operation can be easily
remedied. You can save time and money in many cases, as you do not need to call
the Miele Customer Service Department.
Information to help you rectify faults yourself can be found at www.miele.com/ser-
vice.
The following tables are designed to help you to find the cause of a malfunction or
a fault and to resolve it.
This section only lists faults that you can remedy yourself. All other faults are
shown in Fault F.
Technical problems
Problem Cause and remedy
The display remains
dark and the Start in-
dicator light is not
flashing after the dish-
washer has been
switched on with the
button.
The dishwasher is not plugged in.
 Insert the plug and switch on at the socket.
The mains fuse has tripped.
 Reset the trip switch in the fuse box or replace the
fuse in the plug (see data plate for minimum fuse
rating).
 If the mains fuse trips again, contact the Miele
Customer Service Department.
The button does not
respond immediately or
only responds once it
has been pressed sev-
eral times.
Energy management: the door was opened or closed
shortly before the button was pressed. As a result,
the dishwasher was already switched on. The elec-
tronic module requires a few seconds to be ready for
operation.
 Wait a few seconds after opening or closing the
door.
 Then press the button.
The dishwasher stops
during a programme.
The mains fuse has tripped. The display is dark and
the dishwasher cannot be switched on.
 Reset the mains fuse (see data plate for minimum
protection rating).
 If the mains fuse trips again, contact the Miele
Customer Service Department.