Miele G 7130 - Setting the Water Hardness Level; Activating Autodos

Before using for the first time
28
Setting the water hardness level
The display will change to the screen
for setting the water hardness.
- You should programme the dish-
washer to the correct water hardness
for your area.
- Your local water authority will be able
to advise you of the water hardness
level in your area.
- Where the water hardness fluctuates
e.g. between 1.8 and 2.7mmol/l (10 -
15 °dH - German scale) always pro-
gramme the dishwasher to the higher
value (2.7mmol/l or 15 °dH in this ex-
ample).
In the event of a fault, it will help the
service technician if you know the hard-
ness of your local water supply.
Therefore, please enter the water hard-
ness:
____________°dH or mmol/l
The dishwasher is programmed at the
factory for a water hardness level of
2.5mmol/l (14°dH – German scale).
 Set the water hardness level in your
area and confirm using OK.
See the “Settings” chapter, “Water
hardness” section for more informa-
tion.
Activating AutoDos
The display changes to the settings
screen for AutoDos (see “Detergent –
Automatic dispensing/AutoDos”).
Even if you do not wish to use Auto-
Dos, you must remove the tag from
the AutoDos lid before running the
first programme sequence (see “De-
tergent – Activating AutoDos”).
You can activate AutoDos.
If you do not wish to use AutoDos
(automatic dispensing), you can manu-
ally dispense the detergent via the de-
tergent compartment (see “Detergent –
Manual detergent dispensing”).
 Select the setting you want and con-
firm with OK.
Automatic dispensing is activated when
the AutoDos indicator light lights up.
This setting applies to all programmes
and can be changed at any time using
theAutoDos button.