Miele G 7216 - Page 34

Settings
34
- Call up information on the program
sequence of your dishwasher
- Set up a Miele@home network with
other WiFi-enabled Miele appliances
Connect using WPS
As an alternative to networking via the
Miele app, you can connect your dish-
washer to your Wi-Fi network using
WPS (Wireless Protected Setup).
Your WiFi router must support WPS.
 Select the Connect using WPS menu
option and confirm with OK.
 Confirm the message Press WPS but-
ton with OK.
 Activate the WPS function on your
router within 2minutes.
 Once the connection has been estab-
lished, confirm the message with OK.
If the connection fails, you have proba-
bly not activated WPS on your router
quickly enough. Repeat the steps above.
Deactivate
If you do not wish to use the Wi-Fi mod-
ule of your dishwasher, you can turn it
off.
 Select the Deactivate menu option.
In the Miele@home menu, the Activate
menu option will now be displayed in-
stead of Deactivate.
Activate
If you wish to connect your dishwasher
to your Wi-Fi network, you can turn on
the Wi-Fi module.
 Select the Activate menu option.
In the Miele@home menu, the Deactivate
menu option will now be displayed in-
stead of Activate.
Displaying Connection status
You can call up the current connection
status of your dishwasher.
 Select the Connection status menu op-
tion and confirm with OK.
 Use the buttons to consecutively
call up the WiFi signal strength, the
name of your router and the associ-
ated IP address.
 Select OK to confirm the messages.
Set up again
This menu option only appears if you
have already connected your dish-
washer to your Wi-Fi network.
Connect using App
 Select the Connect using App menu
option.
 Follow the user navigation in the app.
Connect using WPS
 Select the Connect using WPS menu
option.
 Follow the instructions on the display.
Reset
This menu option only appears if you
have already connected your dish-
washer to your WiFi network.
You can use this menu option to reset
all WiFi module settings to the factory
default settings.
The network configuration should be re-
set whenever a dishwasher is being dis-
posed of or sold, or if a used dishwasher
is being put into operation. This is the
only way to ensure that all personal data
has been removed and the previous
owner will no longer be able to access
the dishwasher.