Frequently asked questions
80
Many malfunctions and faults that can occur in daily operation can be easily reme-
died. You can save time and money in many cases, as you do not need to contact
Miele Customer Service.
Information to help you rectify faults yourself can be found at www.miele.com/ser-
vice.
The following tables are designed to help you to find the cause of a malfunction or a
fault and to resolve it.
This section only lists faults that you can remedy yourself. All other faults are
shown in Fault F.
Technical faults
Problem Possible cause and solution
The display remains dark
and the Start indicator
light is not flashing after
the dishwasher has been
turned on with the
button.
The dishwasher is not plugged in.
Insert the plug.
The circuit breaker has tripped.
Reset the breaker (see data plate for the correct
fuse rating).
If the breaker trips again, contact Miele Customer
Service.
The button does not
respond immediately or
only responds once it
has been pressed sev-
eral times.
Energy management: the door was opened or closed
shortly before the button was pressed. As a result,
the dishwasher was already switched on. The elec-
tronic module requires a few seconds to be ready for
operation.
Wait a few seconds after opening or closing the
door.
Then press the button.
The dishwasher stops
during a program.
The circuit breaker has tripped. The display is dark and
the dishwasher cannot be turned on.
Reset the breaker (see data plate for minimum pro-
tection rating).
If the breaker trips again, contact Miele Customer
Service.
Fault messages
Problem Possible cause and solution
One of the following
faults appears in the dis-
play:
Before remedying the fault:
Turn off the dishwasher.
To Next Page
