Priming the neutralizer
dispensing system
Before using the washer/disinfector for
the first time, or if the washer/disinfector
has been operated with an empty neu
-
tralizer container, the dispensing sys
-
tem must be primed. Please proceed
as follows:
1. Press the ON/OFF button to turn
washer/disinfector off.
2. Using a long, thin object (e.g.,
straightened paper clip), press in
switch "A", located on the left hand
end of the control panel, for 3
1
/2 min
-
utes.
Each time the system is primed, any
neutralizer which runs into the wash
cabinet must be washed out by running
the RINSE cycle.
After this cycle is run, the dispensing
system is filled and ready for use.
To reduce the pH level of the wash so
-
lution after the alkaline wash phase, cy
-
cle can be programmed to automati
-
cally inject Neutralizer during Interim
Rinse I phase as follows:
1. The cycle must be set to "Interim
Rinse I with neutralizing agent dis
-
pensed", refer to "Programming spe
-
cial functions, Adding Neutralizer"
Adding Neutral pH Detergent
30
To Next Page
Loading...
