With the aid of the following explanatory
notes, minor problems can be cor
-
rected without contacting the Miele
Technical Service Department.
IMPORTANT: Any work on the washer/
disinfector electrical components
should only be carried out by a quali
-
fied person.
In the event any problems cannot be
corrected, please contact the Miele
Technical Service Department.
Warning lights
DRAIN/FILL warning light flashes
^ Check that both water intake hoses
are connected to the water supply
and that the valves are turned on.
^ Check if inlet water filters are
clogged.
^ Check the drain hoses. They should
be no higher than 3 feet (1 m) from
the base level of the washer/
disinfector. The inner diameter of the
hoses should be no less then
3
/
4
’’
(2 cm).
^
Check if any hoses are kinked. If so,
straighten.
^
Activate DRAIN cycle. Once DRAIN
is complete, restart processing cycle.
The REACTIVATION light is on
^
Replenish the water softener. Please
refer to "Reactivating the water soft
-
ener".
The DETERGENT light is on
^
The liquid detergent container has to
be refilled.
The NEUTRALIZER light is on
^
The neutralizer container has to be
refilled.
The display shows two dashes
^ Contact the Miele Technical Service
Department. The washer/disinfector
must be reset by a trained techni-
cian.
Correcting minor problems
46
To Next Page
Loading...
