3. Altering temperatures T1 (wash
temperature) and T2 (final rinse tem
-
perature) in the DISINFECTION
VARIO 93°C-10 MIN cycle
CAUTION: The operator is responsi
-
ble for monitoring and guaran-
teeing the standard of disinfection in
the routine disinfection cycle.
Disinfection parameters should be
checked regularly using chemical in
-
dicators, and contamination levels
checked and documented periodi
-
cally using biological indicators.
The wash and final rinse temperatures
are set as standard at 113°F (45°C) and
200°F (93°C), respectively. If a wash
temperature of 140°F (60°C) is re-
quired, this can be set in the following
manner:
^ Turn off the washer/disinfector.
^ Press DRAIN and DRYING touch
pads at the same time, while turning
on the machine. "P1" appears in the
display field.
^
When DISINFECTION VARIO
93°C-10 MIN touch pad is pressed,
"30" appears in the display. Press
DRYING touch pad to change "30" to
"31" or vice versa.
^
When RINSE touch pad is pressed,
"40" appears in the display field. A
change from 40 to 41 would imply
that no thermal disinfection takes
place in the DISINFECTION VARIO
93°C-10 MIN cycle.
The following options are possible:
Setting Main Wash
tempera
-
ture
Rinse tem
-
perature
30 / 40 113°F
(45°C)
200°F
(93°C)
30 / 41 113°F
(45°C)
176°F
(80°C)
31 / 40 140°F
(60°C)
200°F
(93°C)
31 / 41 140°F
(60°C)
176°F
(80°C)
^ Press START touch pad. "SP" ap-
pears in the display field.
^ Press START again. The change is
now stored and the display field
clears.
Programming special functions
41
To Next Page
Loading...
