There is a 9-pole sub-D socket on the
back of the machine for data transfer
between the Profitronic unit and an
external report printer or a PC.
The serial interface is RS 232
compatible.
Various printers can be used as
external printers:
–
Epson-compatible
(contact Miele for a list of suitable
models).
–
HP Laserjet
For the interface configurations see
"PC/Printer Function" in the
Programming manual.
Pin configuration in the 9-pole sub-D
connector at the back of the machine:
5 GND(base)
3 TXD (transmit)
2 RXD (receive)
1-4-6 (linked)
7-8 (linked)
A standard null-modem or laplink cable
can be connected.
The extension cable to the printer/PC
must not exceed 13 m.
Please note the following when
connecting a printer or PC:
– Only use an industry-standard PC or
printer (e.g. in Germany TÜV, or VDE
approved),
– the size of the printer or PC must be
taken into account when installing
the machine.
The report printer settings are
described in detail in the Programming
manual under "PC/Printer function".
Data transfer
40
To Next Page
