Drying unit (TA) - Maintenance
The CHANGE TA COARSE and
CHANGE TA FINE service
programmes have been allocated to
programme places 62 and 63
ex-works. If required, they can be
moved to other programme places.
See "System functions" in the
Programming manual.
Changing the coarse filter
The coarse filter should be changed
when the message CHANGE COARSE
FILTER flashes in the display.
^ Open the front of the control unit
cabinet.
^
Remove the filter grille from the
drying unit.
^
Replace the coarse filter. The soft
side of the filter must face the front.
^ Replace the filter grille and push it
upwards to secure it.
^ Close the front of the control unit
cabinet.
After the coarse filter has been
changed, reset the operating hours
counter to zero, as follows:
^
Select the CHANGE TA COARSE
programme.
^
Press the Start button 6.
When the service programme has
ended, a message will appear in the
display.
^
To üCONTINUE< press 6.
Maintenance
48
To Next Page
