Miele G 881 Novo Stella User Manual

Technical Information
101
G 600/G 800
6.8.5.3.1 Accessing Fault Codes
1. Access Service Mode 2.
2. Turn the program selector switch to the 1 o’clock position.
3. The fault code will be shown in the display, e.g., F01, F02, etc.
4. Use the fault chart (Table 6-29) to determine which fault has been stored in the
dishwasher.
5. Turn the dishwasher off.
Fault code Fault
F00 No error
F01 NTC or NTC connections open-circuited
F02 NTC or NTC connections short-circuited
F03 Electronic failure, selector switch position not found
F04
Heating failure - heating circuit opened or defective
electrical component in heating circuit
1
F05 Water drainage failure, heater pressure switch
F06 Too few pulses at flow meter / start of water intake
F07 Too few pulses at flow meter / end of water intake
F08 Water intake failure, heater pressure switch
F09
Heater pressure switch not switching on at the end
of thermal stops
3 dashes (---) in display
Indicates a F1, F2, F4, or F9 fault is stored in the
memory
Table 6-29: G 681, G 881 Novo Stella, G 886 Novo Stella Plus Fault Code Chart
1
All wash programs can be run, but the heating element will not function during the cycle.
6.8.5.3.2 Deleting Stored Fault Codes
1. Access Programming Mode.
2. Press the Start button twice and turn the dishwasher off.
6.8.5.3.3 Operating Hours
1. Access Service Mode 2.
2. Turn the program selector switch as shown in Table 6-30 below.
Selector switch position Display
2 First 3 digits of total operating hours
3 Last 3 digits of total operating hours
Table 6-30: G 681, G 881 Novo Stella, G 886 Novo Stella Plus Operating Hours
Example:
2 o’clock position: 007
3 o’clock position: 127
Total operating hours: 7.127 hours
6.8.6 G 885

Miele G 881 Novo Stella Specifications

General

Type	Freestanding
Control Panel	Electronic
Place settings	12
Energy efficiency class	A
Height	85 cm
Width	60 cm
Depth	60 cm
Color	White