Warning and Safety instructions
13
Correct installation
The dishwasher must be install
ed
and connected in compliance
with the installation diagram supplied.
Take care, both before and during installation of the dish‐
washer
, not to cut yourself on the metal parts. Danger of in‐
jury. Wear protective gloves.
The dishwasher must be correc
tly aligned to ensure problem-free
operation.
In or
der to ensure stability, built-under and integrated dishwash‐
ers must only be instal
led under a continuous worktop which is se‐
cured to adjacent cabinetry.
If you want to convert your freestanding dishwasher to a built-un‐
der ("U") model, you will need to order the appropriate conversion
kit. If you remove the existing plinth, you must replace it with a U-
model plinth. This is necessary to avoid the risk of injury caused by
protruding metal parts.
The door spring
s
must be adjusted equally on both sides. They
are correctly adjusted when the door remains stationary when left
open at 45°. It is important that the door is held in place by the
springs and cannot fall open.
The appliance may only be used with correctly adjusted door
springs.
To Next Page
Loading...
