Miele HG06 - Water Inlet Fault

Problem solving guide
65
Water inlet fault
Problem Cause and remedy
The In-operation indica‐
tor is fl
ashing quickly.
The buzzer is sounding.
The Inlet/Drain indica‐
tor is flashing on and
off.
The stopcock is closed.
 Open the stopcock fully.
The In-operation indica‐
tor is fl
ashing quickly.
The buzzer is sounding.
The Inlet/Drain indica‐
tor is flashing and fault
code  or  has ap‐
peared in the display.
Before rectifying the problem:
 Switch the dishwasher off with the  butt
on.
The water intake is restricted.
 Open the stopcock fully and start the programme
again.
 Clean the water inlet filter (see "Maintenance").
 The wat
er pressure at the intake is lower than 30
kP
a (0.3 bar).
Seek professional advice.