Programme options
50
Adjust Sensor wash
You can adjust the Sensor wash pro‐
gr
amme so that it will remove stubborn
soiling in a lightly soiled load.
Op
en the door.
Switch the dishwasher off with the
button, if it
is switched on.
P
ress the programme selector button
in, and whilst holding it in switch
the dishwasher on using the but‐
ton.
Keep the programme selector button
pressed in for at least four sec‐
onds until the lower right hand pro‐
gramme indicator comes on.
If this does not happen, start the proce‐
d
ur
e from the beginning again.
Press the Short button 5 times.
The Shor
t indicator will flash rapidly 5
t
imes at intervals.
The flashing sequence in the display in‐
d
ic
ates whether Adjust sensor wash is
activated or not.
– : "Ad
just sensor wash" activated
– : "Adjust sensor wash" switched
off
Press the programme selector button
if you wish to change the setting.
The setting is now stored in memory.
Switch the dishwasher off with the
butt
on.
To Next Page
Loading...
Need help?
General
