IMPORTANT SAFETY INSTRUCTIONS
11
The water-connection pressure needs to be between 7.25 and
145 psi (50 and 1,000kPa).
A damaged dishwasher could be dangerous. If the dishwasher
gets damaged, turn it off at the electricity supply immediately and
contact your Miele dealer or Miele Customer Service.
The manufacturer’s warranty may be invalidated if the appliance is
not repaired to Miele authorized service standards.
We recommend replacing defective components with original
parts. If original Miele parts are installed correctly, Miele ensures full
compliance with safety requirements and the warranty remains valid.
During installation, maintenance, and repair work, the dishwasher
must be disconnected from the electricity supply (turn it off and with-
draw the plug from the socket).
If the power cord is damaged, it must only be replaced with a spe-
cific cord of the same type (available from Miele Customer Service).
For safety reasons, this must only be done by Miele Customer Ser-
vice or a service technician authorized by Miele.
Do not sit the dishwasher on the hose. The hose needs to be free
of kinks and able to move freely after installation. Do not place hose
or power cord next to a heat source e.g. hot water pipes. Do not ex-
pose hose or power cord to corrosive substances or their vapors
(e.g. chloride). Damage of hose or power cord could cause electrical
shock or water damage.
This dishwasher is supplied with a special bulb (depending on the
model) to cope with particular conditions (e.g., in terms of tempera-
ture, moisture, chemical resistance, abrasion resistance, and vibra-
tion). This lamp must only be used for the purpose for which it is in-
tended. The lamp is not suitable for room lighting. Replacement
bulbs may only be installed by a Miele authorized technician or by
Miele Customer Service.
To Next Page
Loading...
Need help?
General
