You can change the standard settings
of your hob.
^
With the hob switched off, touch the
hob ON/OFF sensor s and the
booster sensor B at the same time,
until P (Programme), S (Status) and
numbers appear in the cooking zone
displays. This shows the current
setting.
To set the programme:
^
Touch the sensor for the front left
cooking zone.
The relevant number will begin to flash.
^ Touch the + or - sensor to set the
required programme.
To set the status:
^
Touch sensor for the front right
cooking zone.
The relevant number will begin to flash.
^
Touch the + or - sensor to set the
required status.
To store the new settings in memory,
touch the B sensor until the displays go
out.
If you do not wish to store the settings
in memory, touch the ON/OFF sensor
until the displays go out.
Programme Status* Setting
P0 Demonstration mode and factory
default settings
S 0 Demonstration mode on
S1 Demonstration mode off
S 9 Factory default settings
reinstated
P1 Keypad tone when a sensor is
touched
S 0 Off
S1 On
* The factory default settings are shown in bold.
Programming
30
To Next Page
Loading...
