Installation
35
Preparing the countertop
Create the countertop cut-out as
shown in the cooktop diagram.
Remember to maintain the minimum
safety distances (see "Safety
clearances").
Wooden countertop
Seal any cut surfaces on the wooden
countertop with a special varnish,
silicone rubber, or resin to prevent the
wood from swelling as a result of
moisture. The sealant must be
temperature-resistant.
Make sure that the sealant does not
get on countertop surface.
The sealing strip ensures that the
cooktop will sit securely in the cut-out
without slipping. Any gap between the
trim and countertop will become
smaller over time.
Wooden countertops
Position the spring clips on the top
edge of the cut-out as shown in the
cooktop illustration.
Fasten the spring clips using the
3.5x25mm screws supplied with the
appliance.
To Next Page
Loading...
