Standby
To save energy, the display goes out
after 10 minutes and the indicator
light for the Start button flashes
slowly.
The display is switched on again by
moving the programme selector or
touching one of the buttons, without any
effect on any programme that is
running.
–
On
Standby comes on:
...ifaprogramme is not selected.
. . . after the Start button has been
pressed in a programme that is
running.
. . . after the end of a programme.
– Not in current prog.
(default setting)
Standby is activated if no
programme selection is made after
the end of a programme - but not
during a programme that is running.
Extended cool down
The cooling down phase which takes
place before the end of a programme
can be lengthened if required. This
makes the garments easier to handle.
The bars show you the setting.
–
from 0-18 mins.
–
Factory default: 0 mins (normal
cooling down period)
The programme duration will increase
accordingly.
You cannot extend the cooling down
time for the Warm air, Cool air,
Woollens handcare or Smoothing
programmes.
Drying levels
Cottons
Please note: Changing the settings for
drying levels in the Settings menu will
also affect the Cottons t
programme.
Minimum iron
You can alter the drying levels for the
Cottons and Minimum iron
programmes.
The bars show you the setting.
– from drier to
– damper
– Factory default: level 4
Machine iron
The drying level Machine iron can be
altered separately in the Cottons
programme.
The bars show you the setting.
–
from drier to
–
damper
–
Factory default: medium.
Settings menu
59
To Next Page
Loading...
Need help?
General
