Miele T 260 - Altering or Cancelling Programmes; Adding or Removing Garments

Altering a programme
If the programme selector is turned to a
different programme after a programme
has begun the
Anti-crease/Finish indi
-
cator light will flash. The indicator light
will go out when the selector is returned
to its original position and the
programme will continue from where it
was beforehand.
After a programme has started, not all
additional options can be switched on
or off (see section "How to dry cor
-
rectly").
To interrupt a programme
^ Switch off the dryer with the
I-ON/0-OFF button.
To continue drying:
^ Switch the dryer back on with the
I-ON/0-OFF button.
The programme will continue, as long
as the cooling down phase has not
been reached.
To cancel a programme and select a
different programme
^
Turn the programme selector to
Fin
-
ish
.
The
Anti-crease/Finish indicator light
will flash by itself to indicate that the
programme has been cancelled.
^
Turn the programme selector to the
programme you require.
^
Switch additional options on or off as
required.
^
Press the START button.
To open the door during a
programme to add or remove
garments
^
Press the
Door button and open the
door.
,
Do not touch the back of the
drum when adding or removing
items. The drum could be very hot -
danger of burning.
^
Items can now be added or removed
early.
To continue drying:
^ Close the door.
^ Press the START button
– The programme will continue.
– The time left shown in the display
may now vary from the actual drying
time.
How to dry correctly
19