Problem Possible cause Remedy
The drying process
goes on too long or
even switches off.
Important: Before attempting to remedy one of the fol
-
lowing causes, switch the dryer off and switch on again
to start the programme again.
Ventilation to the dryer is in
-
sufficient (e.g because it is
installed in a room which is
too small).
Open a door or window
while the machine is in op
-
eration for increased air
flow.
The laundry was not suffi
-
ciently spun.
Spin the laundry in the
washing machine at the
highest possbile spin
speed.
The dryer has been over
-
loaded.
Observe the maximum
loads for the programme
selected.
Metallic components, e.g.
zips have prevented the
dryer from registering the
correct moisture level in the
laundry.
In future use a TIMED
DRYING programme for
these garments.
The fluff filter is blocked. Clean the fluff filter.
The vent ducting or the
ventilation outlet (e.g. win-
dow or wall vent) is
blocked.
Check all parts of the ex-
traction system on a regular
basis (e.g. wall vent, exter
-
nal grille, bends in the
ducting etc.) and make
sure they are free of any
hindrance. Remove any
fluff.
Problem solving guide
25
To Next Page
Loading...