Starting a programme
^
Touch the green illuminated Start sensor.
G
Cottons 10:21
[
Normal - Extras (See :)
Time left: 2:03 h
Change !
–
The time left counts down in the display.
–
Symbols in the display show which section of the
programme has been reached.
Time left
The following factors all affect the estimated time left: the
residual moisture after spinning; the type of textile; the load;
the ambient room temperature; fluctuations in the power
supply or a programme interruption.
The time left is continually monitored and altered during
drying. This is why the time shown in the display may
fluctuate during the programme. This is quite normal.
Programmes can also finish earlier than expected, if, for
example, particularly fine fabric is being dried, the load is
very small or items were partially dry beforehand.
Some changes can be made after starting a programme:
Selecting a different programme
You cannot change to another programme once a
programme has started (this prevents unintentional
alterations).
You will need to cancel the current programme before you
can select a new one.
Start at / Finish at: Changing the time of day
^
Touch the Change sensor.
^
Select the Start at or the Finish at option.
^
Use
+ or - to alter the time of day.
^
Confirm the time you have selected with the
OK sensor.
3. Start the programme
29
To Next Page
Loading...
Need help?
General
