Cleaning the cooling fins
(bottom right grille)
,
In general, the cooling fins do
not need cleaning. They should only
be cleaned if the drying process is
taking an exceptionally long time
due to a very high level of dust or
fluff in the room in which the dryer is
installed.
Use the yellow lever supplied to open
the bottom right grille.
^
Insert the lever in the middle of the
gap at the top and lift it up gently
(see arrow) until the grille opens out
at the top.
^
Now remove the grille by pulling it
diagonally upwards.
^
Check whether the cooling fins are
clogged.
,
Danger of injury.
Do not touch the cooling fins with
your hand. You could cut yourself.
,
To prevent damaging the
cooling fins, only pass the vacuum
cleaner brush over them lightly,
without applying any pressure.
^ Vacuum up any soiling carefully
using a vacuum cleaner dusting
brush or small crevice nozzle.
^
To replace the grille, first insert the
bottom of the grille (as shown).
^
Then push the grille firmly into
position at the top.
Problem solving guide
53
To Next Page
Loading...
