Problem Possible cause Remedy
:
Clean the plinth
filter which is
located in front of
the heat-exhanger
appears at the
end of a
programme.
This is a reminder to
clean the fine filter in
front of the heat
exchanger unit under
running water.
–
Clean the fine filter. See
"Cleaning and care".
To delete the message:
–
Touch the OK sensor.
;
Fit plinth filter
Fit the plinth filter
appears and the
programme
cannot be
started.
The fine filter is
missing or has been
replaced the wrong
way round.
–
Replace the fine filter
correctly.
–
See "Cleaning and care".
–
Switch the dryer off and then
on again.
Removing the fine
filter during a drying
cycle will cause the
programme to be
cancelled.
;
Technical fault
F1
A programme cannot
be started while there
is a fault message in
the display.
– Make a note of what is shown
in the display.
– Switch the dryer off and then
on again.
– If a programme still cannot
be started, Call Miele Ser-
vice.
Comfort cooling
The programme has
finished but the
laundry is still being
cooled down.
–
You can either unload the
drum and leave the laundry
to cool at room temperature
or leave it in the dryer to
continue cooling.
Problem solving guide
48
To Next Page
Loading...
Need help?
General
