Installation and connection
39
Building under a continuous
worktop / in a kitchen run
Building under kits must only be
installed/dismantled by a suitably
qualified fitter.
– A special building-under conversion
kit* with a cover plate to replace the
appliance lid is required. It must be
fitted by a Miele approved technician
to ensure electrical safety. N.B. If you
wish to push your appliance under a
worktop and there is space to do this
without removing the lid, the building
under kit is not necessary. Otherwise
it is essential.
– Fitting instructions are supplied with
the conversion kit.
– N.B. When built under, drying times
may be longer.
– The electrical socket must be located
in an accessible position near the
appliance.
With niche heights of:
– 830-840 mm, longer screw feet* are
required.
– 870-885 / 915-930 mm, one or two
raising kits* are required.
* accessory available to order
Washer and dryer stack
The tumble dryer can be combined with
a Miele washing machine in a washer-
dryer stack. The appropriate Miele
washer-dryer "WTV" stacking kit* is
required.
* accessory available to order
Levelling the dryer
The appliance must stand perfectly
level on all four feet to ensure safe and
proper operation.
The screw feet can be adjusted to
compensate for unevenness in the floor.
To Next Page
Loading...
