Programmable functions
54
Extending the cooling down
time
The cooling down phase which takes
place before the end of a programme
can be lengthened if required. This
makes the garments easier to handle.
Follow steps (,, ...) to
programme and store in memory.
Before you begin, ensure the
following:
– The tumble dryer is switched off.
– The door is closed.
– The programme selector is pointing
to Finish.
Press the Start button and keep it
pressed in whilst carrying out steps
-.
Switch the tumble dryer on.
Wait until the indicator light for the
Start button lights up constantly . . .
. . . and then release the Start button.
Turn the programme selector to
Cottons Machine iron.
The Empty the container indicator light
will flash seven times.
The option selected will be displayed
by a number which will alternate with
.
Factory default
Cooling down 5 minutes longer
(The Clean out airways indicator light
will also flash once)
Cooling down 10 minutes longer
(The Clean out airways indicator light
will also flash twice)
Pressing the Start button switches
between the options.
Switch the tumble dryer off.
The setting you have selected is now
stored in memory. You can change it
again at any time.
To check the setting:
Carry out steps -.
Switch the dryer off after checking
the indicator lights.
To Next Page
Loading...
